空調移機的主要步驟如下：
The main steps of air conditioning relocation are as follows:
前期準備：需要至少兩名或以上的專業制冷修理工，攜帶全套的工具和安全設備。
Preliminary preparation: At least two or more professional refrigeration repairmen are required, carrying a complete set of tools and safety equipment.
回收制冷劑：啟動空調至制冷狀態，運行約5-10分鐘后關閉，隨后拔下電源插座，利用扳手擰緊空調外機的保險帽，以實現制冷劑的回收。
Recycling refrigerant: Start the air conditioner to the cooling state, run it for about 5-10 minutes, then turn it off. Then unplug the power socket and use a wrench to tighten the safety cap of the air conditioner's external unit to achieve refrigerant recovery.
拆卸室內機：這一步需要注意防止冷凝水流入線路板，并確保室內機連接的絲紋得到保護，防止搬運過程中的損壞1 2 3。
Dismantling the indoor unit: This step requires attention to prevent condensation water from entering the circuit board, and ensure that the threads connected to the indoor unit are protected to prevent damage during transportation.
拆卸室外機：首先拆除連接室外機的各種部件，包括鎖母、螺絲等，并需注意對部分零件進行單獨放置和標記，以免移機后出現缺少零件的問題2 3。
Disassembling the outdoor unit: First, remove various components that connect the outdoor unit, including locking nuts, screws, etc., and pay attention to placing and marking some parts separately to avoid missing parts after moving the unit.
安裝：當所有部件都已拆卸完畢后，接下來是對空調進行移機并重新安裝的過程。首先確定新位置，然后小心地將各個部件搬過去并進行安裝2 4。
Installation: After all components have been removed, the next step is to move and reinstall the air conditioner. Firstly, determine the new location, then carefully move the various components over and install them.
檢驗：完成上述步驟后，需要進行最后的檢查，如用洗滌劑進行檢漏，觀察每個接頭的狀況，確保沒有泄露后再旋緊閥門保險帽
Inspection: After completing the above steps, a final inspection is required, such as using detergent for leak detection, observing the condition of each joint, and ensuring that there is no leakage before tightening the valve safety cap
